Connect with us

Alternate iPhone charger design

Discussion in 'General Electronics Discussion' started by krish82, Oct 20, 2017.

Scroll to continue with content
  1. krish82


    Oct 20, 2017
    I am working on a project where I want to redesign the iPhone charger circuit board.
    The charger I am thinking of is this one:

    I want the same quality, but basically rearranging so that the usb port is on the middle of the longest side.

    Anyone that can help me with this?
    Either actually rearranging a physical charger or redesign the PCB so that I can contact a production facility.

    Looking forward to hearing your thoughts.

  2. Alec_t


    Jul 7, 2015
    Welcome to EP!
    The circuit is presumably copyrighted, patented or otherwise protected as Intellectual Property (IP), so you would need to get the IP rights holder's permission to go into production.
    The circuit as is does not have the resistors defining specific voltages on the USB data lines, which an iPhone would be looking for.
  3. krish82


    Oct 20, 2017
    The project is a home project, so it’s not that a mass production here.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day