Connect with us

Altera Flex 10k probleem

Discussion in 'General Electronics' started by Marc, Jun 20, 2009.

Scroll to continue with content
  1. Marc

    Marc Guest

    Hi,
    I have a problem with bringing out the INIT_DONE puls out of an Altera Flex
    10k EPLD. I use Quartus II software on a PC.
    I also use the EPC2 configuration device.
    I enabled this bit in the design software and used a pull-up resistor of 1k
    at the INIT_DONE -pin.
    The signal stays low, always and it should go high when entering user mode.

    Can anybody help me with that?

    Marc
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-