Connect with us

Allegro 2916B Dual Full Bridge PWM Motor Driver

Discussion in 'General Electronics' started by ERIC SHAIK, Dec 10, 2004.

Scroll to continue with content
  1. ERIC  SHAIK

    ERIC SHAIK Guest

    I'm trying to drive a bi-polar motor with this chip.

    There is a Phase, 2 currents and a Vref for each "H-Bridge."

    Is it mandatory to use all of these inputs in order to get any output ?

    The app notes state:
    The UDN2916B is a 24 pin dual inline plastic batwing package with copper
    lead-frame and heat sinkable tabs for improved power dis.. capabilities.

    For PWM (pulse width modulation) control, the max out currentt is determened
    by the user selection of reference voltage and sensing resistor.

    2 Logic level inputs (I0 and I1) allow digital selection of the motor
    winding current at 100%, 67% 33% or 0% of the max level per the table

    Current control truth table

    I0 I1 Out Current

    L L Vref/10Rs=Itrip 100%
    H L Vref/15Rs = 2/3 Itrip 66%
    L H 33%
    H H 0 %

    General : The PHASE input to each bridge determines the
    direction motor winding current flows.

    The fast currentt decay is desireable in half-step and high-speed
    applications. The PHASE, I0 and I1 inputs float high.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-