Connect with us

ADemco Vista 40 issue, undoubtedly user error

Discussion in 'Troubleshooting and Repair' started by larryfirman, Dec 23, 2010.

Scroll to continue with content
  1. larryfirman

    larryfirman

    1
    0
    Dec 23, 2010
    Greetings, all.

    After a dinner preparation disaster, the smoke alarm was activated (too late, I see that a heat alarm would be more suitable for a kitchen).

    Now the keypad shows the fire code, & the message NOT READY. I've huffed & puffed & cleaned the smoke detector as best I can, but entering the code + off, as the manual states, is ineffective.

    In my community, a security service, rather than an alarm company, does the monitoring, but they have the same knowledge level as yours truly.

    I'd appreciate your suggestions. Thank you in advance. Larry, Baton Rouge
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-