Maker Pro
Maker Pro

ademco vista 20p setup

T

teknot

Jan 1, 1970
0
Guardog, what do you mean "enabled address 17 keypad in 1*90" ? I've never
seen anything about that in the vista 20p installation guide or the6150rf
install guide.

Also, should I set the panel "RF House ID code" the same as the 6150rf and
the 5804BD? Or should just set the 6150rf and the 5804BD the same and
program the panel(*24) to 00 or a different number?
 
G

Guardog

Jan 1, 1970
0
Sorry I meant *190, you have to enter 1-0 in that loaction to enable
the second keypad. You have to set the house ID in *24 to the same ID
you put into the 5804bd. I don't think the 6150rf needs to have that
ID set into it, but I haven't used a 5804bd in a long while so I'm not
sure.
 
Top