Maker Pro
Maker Pro

Ademco / ADT Parts

I have the following parts, and was wondering if I can combine them to
make a wireless system. Jim Rojas has helped me before with the ADT
Panels, great guy, but can I program them normally with my 6139, or
can I get a programming sheet? THe parts are as follows:

SA6128 (smallerish keypad)
20ADT panel (SA20-ADT)
6139 Keypad (good lcd keypad)
A board that says XM n5850-19v2 on a sticker and SA-4HORGEN)
SA5882-2L (wireless receiver)
Vista50PADT (I have the book, but can I access it all properly with a
6139)

I want to make a system out of these parts. Ideally, I would like to
use a board, the wireless receiver and the SA6128 keypad, and program
it with the 6139. Is this possible?

As always, thanks guy.

David
 
Top