Connect with us

40 pin lcd to 50 pin controller board

Discussion in 'General Electronics Discussion' started by Kody, Feb 17, 2017.

Scroll to continue with content
  1. Kody

    Kody

    2
    0
    Feb 17, 2017
    so I am doing this project where I'm making my own monitor for things that use HDMI and vga and all that. The monitor I got for it has a 40 pin connector and the controller board has a 50 pin connector in it. I don't really have a lot of time or money for this project so I was wondering if I can just solder the wires on the board and the monitor together but I'm not sure what pins Controll power or signal or anything. My LCD screen is off a hp pro book 4545s and my controller board I bought from this link https://www.amazon.com/HDMI-Controller-Board-1280x800-panel/dp/B01MS13A5W . I would really appreciate it if I could get some help asap. Thank-you.
     
  2. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,362
    2,757
    Jan 21, 2010
    Are you certain that the display and the controller are compatible?

    Do you have the datasheets for both?
     
  3. Kody

    Kody

    2
    0
    Feb 17, 2017
    I don't have the data sheets but I was told that I can solder the wires together if I can figure out what pin is for what. But I can't find any info on the pins
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-