V
Victor
- Jan 1, 1970
- 0
G'day all
For a project, I will be running 3 phase (+ earth) to a DB and then
splitting it up into a 3 phase part to run 3p motors off and a single
phase section (for 1p motors).
I want to use a switch to utilise only one section (3p or 1p) at a
time, so basically using a 1-0-2 switch . My question is, are there any
4 pole switches that I could use? I've been looking through Clipsal but
haven't seen anything so far.
The max current (for the 3p part) will be 32A and I'd prefer it to be
at least IP65.
cheers
For a project, I will be running 3 phase (+ earth) to a DB and then
splitting it up into a 3 phase part to run 3p motors off and a single
phase section (for 1p motors).
I want to use a switch to utilise only one section (3p or 1p) at a
time, so basically using a 1-0-2 switch . My question is, are there any
4 pole switches that I could use? I've been looking through Clipsal but
haven't seen anything so far.
The max current (for the 3p part) will be 32A and I'd prefer it to be
at least IP65.
cheers