Maker Pro
Maker Pro

3 questions about Orcad 9

F

fatango

Jan 1, 1970
0
Hello,

I use Orcad 9 and i have 3 questions :
1 . How can i forbid (in Layout) the autoroute to route a component on
the TOP (because i can't weld this component on the TOP)
2 . How can i set a pad to center the tracing paper (in Layout). I
don't success to set a pad without to put a component in capture.
3 . How is it possible to set Layout to be able to change the width on
the same net during the autorouting. For exemple, the net start with a
large width and when the net have to pass between 2 pads very close,
the width changes and becomes thin and after become back large.

Thanks very much for answer

Fatango
 
Top