Maker Pro
Maker Pro

20p with keyfob for garage door

N

Neo

Jan 1, 1970
0
I am using Vista-20p with a wireless reciver. The home owner wants
to open and close the garage door with a keyfob. Since I am
relatively new on this panel dont know how to do this. anyone can
help me out

Thanks in advance
Neo
 
A

A.J.

Jan 1, 1970
0
You can either use the output on the keypad or the onboard relay output.
 
J

JoeRaisin

Jan 1, 1970
0
Neo said:
I am using Vista-20p with a wireless reciver. The home owner wants
to open and close the garage door with a keyfob. Since I am
relatively new on this panel dont know how to do this. anyone can
help me out

Thanks in advance
Neo

Onboard relay to close the circuit but you will need a wire from the
opener to your panel. Programming can be a bit tricky but if you read
carefully and take your time it usually goes smooth.

If you are using the RF keypad the should be a relay on it as well but
whenever I try using the onboard zones or relay on the keypads I always
get mighty confused and end up calling tech assist - then i get it working.
 
T

Tommy

Jan 1, 1970
0
If he dosen't already have a keyfob. try a street smart code encryptor. much
less programming.
 
N

Neo

Jan 1, 1970
0
You can either use the output on the keypad or the onboard relay output.

Relay on the keypad do you mean on a 6150 RF , How would I do that
please do help me out the service date is nearing.

Neo
 
Top