Frank Vassallo
- Mar 25, 2017
- 2
- Joined
- Mar 25, 2017
- Messages
- 2
Hi
I have an application where i have three 0 to 10v analogue outputs controlling one VFD. The VFD will need operate on the highest analogue value. So if unit A sends 5v , Unit B sends 5.5v and Unit C sends 4.8v then the VFD should operate on the 5.5v. Can i just simply connect all three outputs from units in parallel. All outputs are diode protected.
Thanks
I have an application where i have three 0 to 10v analogue outputs controlling one VFD. The VFD will need operate on the highest analogue value. So if unit A sends 5v , Unit B sends 5.5v and Unit C sends 4.8v then the VFD should operate on the 5.5v. Can i just simply connect all three outputs from units in parallel. All outputs are diode protected.
Thanks