Maker Pro
Login Join Maker Pro
Or sign in with

Menu

Connect With Us

Network

Search results

  1. N

    Resistor value identification

    No I am testing it out of the circuit, I am in the US too. the board is from a small air compressor. it connects to a pressure switch and to a 110 volt fan and the small compressor motor itself.
  2. N

    Resistor value identification

    yes R4, also I was wrong about the reading I was getting, when I set my meter to 2k it reads 5.65 and when I put it on 200 I get no reading.
  3. N

    Resistor value identification

    That's not the original bending of the leads, I sent my wife to radio shack with to see if they had one the idiot there bent them straight. Then he told her to go to Ace hardware or Lowes to get one cause they hade more resistors than radio shack. here is a couple images of the board...
  4. N

    Resistor value identification

    ok I will get a picture of the board and yes it ran very hot and I agree I don't trust the colors either. send an image of the board in a few minutes. I did try and measure it, I had my meter set on two hundred omhs and it read 5.56 out of the circuit. when I set it any higher than 200 I got no...
  5. N

    Resistor value identification

    probably not the best picture but I think its green black brown then the 4th I think is black which is throwing me off.
  6. N

    Resistor value identification

    Can anyone tell me what the value of this resistor is? https://skydrive.live.com/redir?resid=9F9074D3C9AAB530!2664
Top