Maker Pro
Login Join Maker Pro
Or sign in with

Menu

Connect With Us

Network

Search results

  1. J

    Receiver woes - basic advice needed

    yes, the load is set correctly in the settings. I'm not sure that it would matter in this case, though, as it shuts off even when there are no speakers attached.. thanks again
  2. J

    Receiver woes - basic advice needed

    Thanks. I did check the load (speaker capacity and impedence) against the settings. To rule all of that out, I just disconnected everything and ran the receiver with nothing connected. Turned it to the radio and cranked it up. Without the speakers to drive it didn't get too hot, but it warmed up...
  3. J

    Receiver woes - basic advice needed

    I wish I had a clip on thermal sensor or an IR one so that I can test if its giving accurate readings!
  4. J

    Receiver woes - basic advice needed

    Thanks for your feedback. Strangely enough, particularly given how my computers look, the inside of the amp is very clean. I got the compressed air in there anyway, but barely any dust came out. I have a schematic and found the two thermal sensors (X0515A00). Unfortunately to get at them...
  5. J

    Receiver woes - basic advice needed

    Hello all, thank you for taking the time to read my post. I have a Yamaha RX-V2400 receiver with an odd issue and would like some basic advice. First about me - I am in computer science, with BASIC electronics knowledge, and I fix most things around the house, but this is a bit above me...
Top