-
Categories
-
Platforms
-
Content
Recent content by ShowMeCablesDrew
-
S
Custom Headset Adapter
That's very true.. I didn't even think about the wind noise. It just may be enough to conceal some, if not all, of the feedback. Another possible problem raised to me was connecting a 3.5mm plug to a 5pin din jack and the power handing difference between the two being an issue. I was told...- ShowMeCablesDrew
- Post #5
- Forum: General Electronics Discussion
-
S
Custom Headset Adapter
Meh That's what I was afraid of. What if I soldered a wire onto pin 3 of the DIN connector and grounded it somewhere on my bike? (this is to connect a headset that has a TRRS connector to my Goldwing motorcycle that has the 5pin din connector for its intercom system) That way everything is...- ShowMeCablesDrew
- Post #3
- Forum: General Electronics Discussion
-
S
Custom Headset Adapter
I am going from 5pin din to TRRS.. (please see attached photos) tip - left audio ring 1 (closest to tip) - right audio ring 2 - mic shield - ground Tip------------------------5 Ring1----------------------4 Ring2----------------------1 Sleeve---------------------2 With the two...- ShowMeCablesDrew
- Thread
- Replies: 6
- Forum: General Electronics Discussion
