-
Categories
-
Platforms
-
Content
Recent content by KatGND
-
Fault from powering with incorrect voltage
Reply to electronics Point Hey everyone. Thanks for the replies duke and steve. Great suggestion. When I tested the switch in it’s open position, I found it has continuity through all 3 pads on each side, but not between both sides. I believe this rules out the switch as the source of the...- KatGND
- Post #4
- Forum: Troubleshooting and Repair
-
Fault from powering with incorrect voltage
Good day everyone! I have a hair straightener that I’d like to repair. Recently I was traveling and I was powering the device with a voltage converter that delivered too much voltage. The device is rated for 100V, and the converter delivered 120V. The straightener worked for a while, and...- KatGND
- Thread
- Replies: 4
- Forum: Troubleshooting and Repair
