So i can also use the internal pull up resistor of the Arduino ( 10k ), compared to the suggested 3.2k will only affect the performance but not the current that flow inside the Arduino. Correct me if im wrong, im a newbie :D
Thank for the reply, but isnt too strong 3.2k pull up to connect it to a microcontroller? ( like an Arduino).
And having a pull up resistor on the collector shouldnt affect the encoder being warm or not?
Pin
Hi guys, i've got an optical encoder from an old ink printer. The model is Agilent h9731 ( datasheet http://pdf.datasheetcatalog.com/datasheet2/9/0pql04k9oru8uez14wx9h3d3657y.pdf )
I wired up the Vcc to 5v, GND to GND and ChanA and ChanB to the oscilloscope and everything works fine but the...