The LM317 has always been for "outputing a variable Voltage"
or so I thought ? it could have applications other than that I may
not be aware of though... but in this instance it is for "Outputing
a variable Voltage" ...
I do not understand your question
What's this "thing"...
Hi,
Here is a circuit I found for a Slow-On , and
my questions for the mods I seek ...
I have a 20Amp 24v DC Motor a : Dayton
Model 6ML03 ,,, and to drive it I have a Dart
Model 65E40 DC Powered Motor Controller.
This motor Controller needs a .5 -to- 10v DC
Signal to run...
I almost forgot !!!
I also used the oatley sets for transmitting a "condition" ..
I use a "length-of-transmission" as the data mode...
for instance, the temperature of my fermenting mead closet, is
normal... it transmitts a 6 second signal... if the temp is low
say 68 deg F...
what I do for simple remote control
here is the type of solution I use for this kind of challenge...
My favorite option is a $35 xmit receiver set from Oatley electronics in
austrailia, set number RX9 and TX9 - they wont let me post the links
to it, sorry, they must be a little...