Maker Pro
Login Join Maker Pro
Or sign in with

Menu

Connect With Us

Network

Recent content by Arky

  1. Arky

    diode for super low voltage?

    The Schottky diodes worked a little, I guess. When it hit the desired RPM it would slightly misfire, but I could easily rev past the set RPM limit. They actually interrupted the signal a bit, but it felt like it wasn't fully grounding the ignition coil signal wires.
  2. Arky

    diode for super low voltage?

    Thanks for your reply! I have the EWD for this vehicle and over the weekend I have found that each igniter wire is within spec as far as voltage. Mine is .5v at idle and 1.5v at redline. I have Schottky diodes come in from Amazon tomorrow (tuesday). I will update this thread after their...
  3. Arky

    diode for super low voltage?

    Ok so after seeing the analog meter in action does appear to be a pulse or waveform? It appears to me that the bee-r 2 step box grounds the ignition signal to make the ignition cut. If the wire I'm trying split is actually a grounding wire will diodes even work like I'm trying to do? If so...
  4. Arky

    diode for super low voltage?

    Here's the voltage on 1 of 3 IGT wires. There are 3 of these wires I need to tie into the 2 step box. I honestly don't know how to interpret these readings accurately. Any help reading the voltages?
  5. Arky

    diode for super low voltage?

    http://www.enginebasics.com/EFI%20Tuning/2step%20rev%20limiter.html The next link is the device I have "BEE-R power builder" and this is the method I am trying to use to hook it up: http://forums.nasioc.com/forums/showpost.php?p=22303812&postcount=21 More reading here...
  6. Arky

    diode for super low voltage?

    I'm not sure. It's a pulse and my DVMM won't read it. I need to get my hands on an analog ASAP.
  7. Arky

    diode for super low voltage?

    I am wiring a 2 step launch control box to a car ECU. I need a wire from the "2 step box" to ground out the signals (from ECU to ignitor) above a set RPM. The single wire from the "2 step box" needs to intercept three separate ignitor signal wires. When I hook them up all up together, the "2...
See more
Top