In article <BDC4CEB5.30FFD%(E-Mail Removed)>,
Robert <(E-Mail Removed)> wrote:
> Just a reminder, all Aerotech RMS motor assembly and dimensional drawings
> are available on the Aerotech website, listed under RESOURCES @
> aerotech-rocketry.com
>
> The nozzle drawings showing the un-drilled versions are on the RCS website @
> rocketmotorparts.com
>
> Only one customer has asked me to burn a CD with all of these PDF's, and if
> you only have a dial-up connection (as I do) it can be too much to download
> more than a few. If you contact me by my e-mail I could burn a CD and send
> it to you also.
>
> There is too much information on the blueprints to include on the
> instruction sheets,
Make a friggin ascii text table of the critical data IN EACH RELOAD.
Delay length, nozzle throat, and whatever the next two most requested
items are.
Jerry
I put errortech into business!!
> and I would prefer to see the correct information used
> for reference rather than from other sources. If there was enough 'positive'
> feedback, I could make a reference sheet with a listing. Make sure you put
> the topic of Blueprints in your email subject, as I tend to delete all
> emails unless they are highlighted (in my address book).
>
> Robert
>
--
Jerry Irvine, Box 1242, Claremont, California 91711 USA
Opinion, the whole thing. <mail to:(E-Mail Removed)>
Please bring common sense back to rocketry administration.
Produce then publish.
http://www.usrockets.com
Ebay auction deals and specials.
http://tinyurl.com/6wlp8
Similar Threads
Linear Mode
