Measuring model parameters

komminenibalaji@gmail.com

Guest

Posts: n/a

02-01-2007, 03:24 AM

Hi,

I am using monte carlo mode simulation in HSPICE. I am varying the VT
and TOX for each of the tarnsistors. I am using MODMONTE=1 so that
HSPICE automatically assigns the different values of TOX and VT to
each transistor in the circuit. Is there anyway of measuring the what
value VT and TOX take in each loop of the iteration for each of the
mosfets? Or could I specify the parameters VT and TOX outside the
model statement like length and width?
Thanks in advance.

Regards,
Balaji.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are Off Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
HSPICE measuring mosfet model parameters	komminenibalaji@gmail.com	Electronic Design	0	02-01-2007 03:27 AM
MOS model parameters for cmosp35	Vitaliy	Electronic Design	1	03-17-2006 09:44 PM
Measuring y parameters	Bob Liesenfeld	Electronic Design	0	04-13-2005 01:15 AM
Why is HP 5370/5345 Time Interval Measuring less accurate trhan Period Measuring	Peter, PE1ECM	Electronic Equipment	1	01-28-2005 05:07 AM
Measuring S - Parameters in Spice	Paul Burridge	CAD	10	08-12-2004 04:23 PM